Halkey Roberts boat valves are made in two parts: the nut on the inside of the SUP board and the valve itself that screws into the nut from the outside of the board. Tightening the two parts together creates an airtight seal that can easily hold 20 PSI of pressure. Replacing a valve is a pretty straight forward procedure and will approximately take 2 minutes. In the following 4 steps we will tell you exactly what to do when you want to replace the Halkey Roberts valve on your SUP board.
Step 1: The tools
The first step is to gather the right tools for the job. Do not use any tools that are not designed for removing a Halkey Roberts Valve! This can permanently damage your board! You will need the grey tool that comes with your SUP board. You can find it in the orange repair kit container. In case you do not have the repair kit, you can simply buy a new one at our webshop.
Step 2: Removing the valve
Grab the grey tool from the orange container and press it firmly on the Valve. Start unscrewing the valve counterclockwise until it is loose enough.
When the valve is loose enough you can just use your hands to unscrew the final part and take out the valve.
Step 3: Fitting the new valve
Make sure the area around the hole is clean and undamaged. If there are strings coming out the hole you grab some scissors and cut them off. Keep in mind that any dirt or strings getting stuck between the valve and the nut will damage the airtight seal permanently. Check if the Halkey Roberts valve that you are going to screw back into place is completely clean and undamaged. Center the nut inside the hole and place back your new valve on the nut. Screw it back on the inner part while holding the bottom of your sup board to support nut and valve.
Step 4: Checking your valve
Now that the valve is back in place tighten it up firmly still using the tool. Remove the tool from the valve and pump up your sup board to 18-20psi. Leave your board inflated and wait approximately 4 hours before checking if your board has lost any air. Is your board still on the same pressure? Congratulations, you successfully replaced your Halkey Roberts valve and you are ready to get back on the water!
Watch the movie below for a video instruction!
Hvis du tilmelder dig Jobe nyhedsbrev, får du en gratis vandtæt taske til din mobiltelefon når du har afgivet din første bestilling.
Bestilt før kl. 12 på arbejdsdage, sendes samme dag
Jobesports.com bruger cookies til optimal hjemmesidepræstation, sociale medier og og reklameformål. Tredjeparts cookies bliver brugt til at give dig sociale medier funktionalitet og tilpassede annoncer. For mere information kan du læse Jobe fortrolighedserklæring. Vi antager, at du accepterer vores cookiepolitik, hvis du fortsætter med at bruge vores hjemmeside.