Mandje0Mandje
Zoeken
Menu
  • Kwaliteit en stijl in watersport sinds 1974
  • Gratis levering en retourneren
  • Op werkdagen voor 12:00 uur besteld, dezelfde dag verzonden
JOIN THE JOBE FAMILY
... en lees als eerste interessante watersportblogs en Jobe nieuws.
Terug naar overzicht

How to: Replacing a Halkey Roberts valve

23 oktober 2019
Halkey Roberts boat valves are made in two parts: the nut on the inside of the SUP board and the valve itself that screws into the nut from the outside of the board. Tightening the two parts together creates an airtight seal that can easily hold 20 PSI of pressure. Replacing a valve is a pretty straight forward procedure and will approximately take 2 minutes. In the following 4 steps we will tell you exactly what to do when you want to replace the Halkey Roberts valve on your SUP board.

Step 1: The tools

The first step is to gather the right tools for the job. Do not use any tools that are not designed for removing a Halkey Roberts Valve! This can permanently damage your board! You will need the grey tool that comes with your SUP board. You can find it in the orange repair kit container. In case you do not have the repair kit, you can simply buy a new one at our webshop.

Step 2: Removing the valve 
Grab the grey tool from the orange container and press it firmly on the Valve. Start unscrewing the valve counterclockwise until it is loose enough.
When the valve is loose enough you can just use your hands to unscrew the final part and take out the valve.

How to: Replacing a Halkey Roberts valve

Step 3: Fitting the new valve
Make sure the area around the hole is clean and undamaged. If there are strings coming out the hole you grab some scissors and cut them off. Keep in mind that any dirt or strings getting stuck between the valve and the nut will damage the airtight seal permanently. Check if the Halkey Roberts valve that you are going to screw back into place is completely clean and undamaged. Center the nut inside the hole and place back your new valve on the nut. Screw it back on the inner part while holding the bottom of your sup board to support nut and valve.

How to: Replacing a Halkey Roberts valve 
 
Step 4: Checking your valve
Now that the valve is back in place tighten it up firmly still using the tool. Remove the tool from the valve and pump up your sup board to 18-20psi. Leave your board inflated and wait approximately 4 hours before checking if your board has lost any air. Is your board still on the same pressure? Congratulations, you successfully replaced your Halkey Roberts valve and you are ready to get back on the water!

Watch the movie below for a video instruction!
 
Krijg Code Mandje
Update je voorkeuren
:
:
Kies eerst een maat
Ik bezoek de online Jobe Expo als een
Jouw cookievoorkeuren

Jobesports.com gebruikt cookies voor optimaal website gebruik en social-media -en adverteer doeleinden. Cookies van derden worden gebruikt voor social media functionaliteiten en gepersonaliseerde advertenties. Voor meer info kan je ons Privacy- en cookiebeleid lezen. Accepteer je deze cookie en de bijbehorende verwerking van je persoonsgegevens?

Meer info
Je kunt je voorkeuren op elk moment wijzigen via Cookie-instellingen onderaan de pagina. Lees het Privacy- en cookiebeleid voor meer informatie.
Jouw cookievoorkeuren
Je kunt je voorkeuren op elk moment wijzigen via Cookie-instellingen onderaan de pagina. Lees het Privacy- en cookiebeleid voor meer informatie.